Minimum floor area Study guides, Class notes & Summaries

NFPA 10 Exam 99 Questions with Verified Answers (SI) - CORRECT ANSWER International System of Units 1 in=. mm - CORRECT ANSWER 25.4 Approved - CORRECT ANSWER Acceptable to the authority having jurisdiction. (AHJ) - CORRECT ANSWER Authority Having Jurisdiction O rganization, office or individual responsible for enforcing requirements of a code or standard, or for approving equipment, materials, an installation or procedure. Shall - CORRECT ANSWER Indicates a mandatory requirement....

NFPA 10 Exam 71 Questions with Verified Answers When should wheeled fire extinguishers be considered? - CORRECT ANSWER • High hazard areas are present. • Limited available personnel are present. Requiring: High agent flow rate, Increased agent stream range, increased agent capacity NON-DOT low pressure fire extinguisher cylinders that pass a hydrostatic test shall have the following recorded on a label: - CORRECT ANSWER • Month and year test was performed (perforated) • Test pre...

Michigan Builders License Exam Questions and Answers Already Passed IRC (International Residential Code) Created to serve as a complete, comprehensive code regulating the construction of single-family, two-family and buildings consisting of three or more townhouse units. First 2 chapters of code book are Administrative Plans or supporting documents are almost always required by the controlling authority prior to issuing a permit. T or F True Does the building official have the authority to re...

The following are types of what? LPG, CNG, piped natural gas or solid fuel (coke). - correct answer Portable fueled salamanders/space heaters National Institute for Occupational Safety and Health (NIOSH) Recommended Exposure Limit (REL) for carbon monoxide - correct answer 35 parts per million (ppm) over an 8 hour period What is the third leading cause of fires in buildings under construction ? - correct answer temporary heating What is direct heat flow through matter? - correc...

Fire Inspector 2 Questions and Answers 100% Solved Fire protection engineers have established _____ PSI as a minimum required residual pressure when computing the available water for flow test results. 20psi The most common gallonage rating for horizontal shaft pumps in use today are _____ - _____ GPM. 500 - 1500 gpm A fire pump serving a standpipe system should be tested ______ weekly A fire department pumper can effectively supply around ______ feet in a high rise building depending on hyd...

Contractor's License Exam Questions and Answers 100% Pass Attachments to structural members The edges of lugs brackets, rivets and bolt heads attached to structural members shall be permitted to extend to within 1 inch of the surface of the fire protection Parapet construction The height of the parapet shall not be less than 30 inches above the point where the roof surface and the wall intersect. Combustible framing in fire walls Adjacent combustible members entering into a concret...

Created to serve as a complete, comprehensive code regulating the construction of single-family, two-family and buildings consisting of three or more townhouse units. - Answer IRC (International Residential Code) Administrative - Answer First 2 chapters of code book are True - Answer Plans or supporting documents are almost always required by the controlling authority prior to issuing a permit. T or F Yes - Answer Does the building official have the authority to render interpretations o...

F-80 Coordinator of Fire Safety and Alarm Systems in Homeless Shelters Test. GOOD As the F-80 C of F holder, you notice a minor defect in the fire protection system and report it to the building owner. In the event the issue is still not corrected three months later, what would be the next step that you are required to take? GOOD Typical causes of fires in homeless shelters are considered which of the following? GOOD Shelter staff members shall be readily identifiable at all times whi...

COSC 275 Exam 1 Palmer Questions and Answers fully solved 2023 Estimating: The process of determining the anticipated cost of materials, labor, and equipment of a proposed project. Take-off: The process in which detailed lists are compiled, based on drawings and specifications, of all the material and equipment necessary to construct a project. The cost estimator uses this list to calculate how much it will cost to build the project. Quantities: Measured amounts of construction...

ADJUSTER PRO EXAM WITH REVISED ANSWERS (2023) Stu has a collection of rare comic books. He wants to purchase theft insurance for his collection, separate from his home and other property. What term most accurately describes the type of policy Stu would purchase? - CORRECT ANSWER-Monoline Policy Which of the following statements does NOT apply to the Standard Fire Policy? - CORRECT ANSWER-It automatically covers wind and vandalism. Which of the following refers to being restored to the ...